Shipping rates starting at as low as 6 EUR!
We would like to inform you that, due to the high volume of orders, processing times have been extended. We apologize for any inconvenience!
Speedball Diazo Photo Emulsion and Sentitizer Ser contains a 781 ml jar of light-sensitive emulsion and Diazo Sensitizer for activation. The emulsion is only compatible with polyester fabrics. A screen prepared with Diazo Photo Emulsion can be used with any water-based or solvent-based printing inks.
Speedball Diazo Photo Emulsion and Sentitizer Ser contains a 781 ml jar of light-sensitive emulsion and Diazo Sensitizer for activation. The emulsion is only compatible with polyester fabrics. A screen prepared with Diazo Photo Emulsion can be used with any water-based or solvent-based printing inks.
Speedball Diazo Photo Emulsion and Sentitizer Ser contains a 781 ml jar of light-sensitive emulsion and Diazo Sensitizer for activation. The emulsion is only compatible with polyester fabrics. A screen prepared with Diazo Photo Emulsion can be used with any water-based or solvent-based printing inks.
Instructions for use:
Be sure to wear gloves. Thoroughly mix the emulsion with the activator, then apply it to the top part of the screen using a squeegee (there is no need to perform this process in a dark room). It is better to apply more emulsion than necessary. Any excess can easily be scraped off with the squeegee and returned to the container. Then repeat the process on the other side of the screen. The screen must be evenly coated, without drips or lumps.
Dry the screen in a place without direct heat or light, in a horizontal position, coated side down. For the best results, keep a gap between the screen and the surface by placing the corners on equal supports. If you plan to make more than 300 prints, it is recommended to apply an additional layer of emulsion to the bottom of the screen after drying. The layers should be thin and even. After the emulsion has dried, place the positive or transparency directly onto the emulsion-coated surface and expose to light. If you need to remove the dried emulsion, the best results are achieved using the Photo Emulsion Remover.
The product has a 3-year shelf life before mixing with the activator. Once mixed, it lasts up to 4 weeks when stored at 30°C, up to 8 weeks at 20°C, and up to 4 months when refrigerated.
Data sheet
You might also like
